You are not logged in.

#1 2019-10-13 17:09:38

macdarren
Member
Registered: 2017-03-20
Posts: 411

reslicing bug....

I had an older model I wanted to reslice with a new resin.  Originally it was sliced with a .1um thickness, however new profile was using 0.05um.  After slicing the layer count did not change and I checked the remote slicer and it reported only slicing half the total number of layers it should have.

Offline

#2 2019-10-13 19:59:19

elshad66
Member
Registered: 2017-03-31
Posts: 118

Re: reslicing bug....

yes there is such a problem, I already wrote and sent the video

https://www.nanodlp.com/forum/viewtopic.php?id=2087

Offline

#3 2019-10-18 08:26:47

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: reslicing bug....

Fixed on the latest beta

Offline

#4 2019-10-27 17:16:54

macdarren
Member
Registered: 2017-03-20
Posts: 411

Re: reslicing bug....

Beta 2414 seems to still exhibits this issue from my original post, at least on the plate page the data doesn't change--I haven't rechecked the remote slicer (not sure what elshad66 was referring to)...and I would add that the resin cost for the model is also not updated...this is minor but still important.  In addition I think one thing that should be 'fixed' is if I edit a plate and totally change the profile at the very least it the plate page should indicate that the slices and other information may not match the profile.....I am ok if I have to manually click 'Regenerate' to update things as I have on occasion found it handy to actually print with a plate that does not match the profile....  (I did this to achieve a unique Z compression) but probably a pretty rare thing.

Offline

#5 2019-10-27 17:58:21

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: reslicing bug....

What exactly do you change which is not affecting plate after reslicing? I am pretty sure it is working correctly for layer depth both locally and remotely.

Offline

Board footer

Powered by FluxBB