nanoDLP

Kvirre

Member

Registered: 2016-08-07

Posts: 47

Printer speed (Z axis movement)

Hi,

My Z axis seems to move at the speed set in Marlin independent of the settings I do in NanoDLP.
This concerns both "Z axis calibration" AND printing from plates.

Usually printer speed is set like G1 Z2 FXXX (where XXX is the speed).
This does not seem to be the case if I look through the terminal and look at the Gcode that NanoDLP executes (produces).

I may have misunderstood how this works, please explain.

Last edited by Kvirre (2016-09-01 07:26:14)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Printer speed (Z axis movement)

You are right, speed settings only effect direct gpio pulse generation and not RAMPS/