nanoDLP

Matt Crall

Member

Registered: 2019-08-26

Posts: 2

Switching to dynamic IP address

We have a printer running nanoDLP on a raspberry pi with a static IP address that we use to connect over the internet. However, we want to be able to make that IP address dynamic to interact more easily with a local network we want to move the printer on to. Any idea how to do that? (I'm a total beginner with this software on raspberry pi so start from square one).

Thanks!

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Switching to dynamic IP address

Check out file called /etc/dhcpcd.conf
There loads of tutorial on how it should configured.

Matt Crall

Member

Registered: 2019-08-26

Posts: 2

Re: Switching to dynamic IP address

How do I access that file? By closing the nanoDLP software and searching for it on the pi?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Switching to dynamic IP address

No need to close nanodlp, even it is ok to do so. But you can SSH into device and do it.