You are not logged in.
Pages: 1
Hi,
I recently manipulated marlin bugfix 1.1. the problem is that the servo doesn't read boot up gcode to close the shutter but it moves correctly by commands. i fixed that by adding [[delay 4]] before M280 command. another problem is that when i turn on the machine, servo doesn't go to preset position. i think both problem relevant somehow. you need to know i set pulse with and default pulse width correctly and it works fine with Muve3D manipulated firmware. also need to know that the servo is tower pro 5010
Last edited by F.m (2019-07-30 13:15:08)
Offline
Pages: 1