nanoDLP

Kenagon

Member

Registered: 2019-06-30

Posts: 1

Resin heating unit

Hi, it will be very useful to add resin heater support (something like "Photonsters PTC Heater Unit" that can be found on thingiverse)

macdarren

Member

Registered: 2017-03-20

Posts: 411

Re: Resin heating unit

While It might be nice to have the Pi control resin temp I would settle for an extra field in the resin profile that is min Resin temp....
Prints would be paused if resin temp was below the threshold....clicking resume could override.
I have a simple heating unit I built from parts and an small printed box inside my printer cover.
It keeps the print chamber heated ... I also made a small clip for the temp sensor to sit in the corner of the vat. in the resin so that is what temp is maintained.
I then set my heater to 33c....and I generally just keep it on but it would be nice if nano could control or at least monitor temps....is there an available AtoD?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Resin heating unit

You can use custom field support and syscalls to implement logical actions you wish.