nanoDLP

Medicompras

Member

Registered: 2019-06-10

Posts: 3

Can read NanoDLP STL or SLC Files from the Raspberry USB Port?

Hi dear

I need know if NanoDLP system can read STL, SLC or PNG Files from the Raspberry USB Port? Or only allow upload the file by the nanodlp website?. I mean if the nanodlp software can work offline in the printer or all time need are connect to internet?. Thanks

Vilal

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Can read NanoDLP STL or SLC Files from the Raspberry USB Port?

It does not net at all. Just local network will be enough.
Yes you can use USB too

Medicompras

Member

Registered: 2019-06-10

Posts: 3

Re: Can read NanoDLP STL or SLC Files from the Raspberry USB Port?

Dear Shahin

Thanks for you quick reply. Please can you confirm me what is the right configuration for the Raspberry PI 3 GPIO pins? becuase I find different configurations in google and in you website and not all is sets is same pins, and I need are sure what is the right GPIO inputs and outputs for make my own PCB. Please check the pictures attach to this message.

This Pins configuration is based in https://www.nanodlp.com/download/schematic.png

Pin 3 - SDA
Pin 5 - SLC
Pin 11 - PWM
Pin 15 - DIR
Pin 16 - EN
Pin 18 - LIMIT
Pin 22 - STEP

This Pin cobfiguration is based in Nanodlp Shield V1.1

Pin 3 - SDA
Pin 5 - SLC
Pin 11 - PWM
Pin 16 - DIR
Pin 15 - EN
Pin 12 - LIMIT TOP
Pin 18 - LIMIT BOT
Pin 22 - STEP

Please can you tell me what is the right Pins configuration for you last design? And can you tell me if is possible I change or set the number of GPIO for each input and output? Thanks for you reply

Last edited by Medicompras (2019-06-12 22:15:39)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Can read NanoDLP STL or SLC Files from the Raspberry USB Port?

Check shield document, nanodlp documents irrelevant as you are not using our own PCB.