You are not logged in.
Pages: 1
Good day.
1. Move to layer (pulse)
2. syscall before
3. gcode before
4. shutter open
5. wait before layer
6. display layer
7. shutter close
8. remove image
9. wait after
10. syscall after
11. gcode after
12. move to wait position
13. wait on top
Tell me how to change the order of actions 4 and 5.
There is an unnecessary glow of the resin. The meaning of the shutter is lost.
Thank you for your development. I apologize for the clumsy translation.
Offline
shutter open runs in parallel to other commands, so by putting delay you can make it works after next step
Offline
Thanks for the answer.
If you set the delay in the polymer settings (first layers), then the shutter works earlier than the delay. It turns out the shutter must be disabled in the settings of the machine, and insert the code shutter and delay in the settings of the polymer (Code Before Each Layer). But then the installation will work the whole cycle of printing.
Or it is necessary to use formulas (I do not know how and what).
If possible, a little more detail.
Thank you, good luck.
Offline
I tried different options.
1. Disabled the shutter in the settings, entered the shutter code in the polymer settings (code before, code after).
2. Turned on the shutter in the settings (before each layer), removed the shutter code from the polymer settings.
All delays (everywhere) set 0. Both options work.
3. Turned on the warm-up time of the projector lamp for 30 seconds.
Turned in the settings of the polymer (delay before, delay after), for 10 seconds.
Both options-shutter works until delay.
The shutter is open for 30 seconds. while the projector is heating up. For 10 seconds. before and after exposure.
Maybe I missed something.
If it is not difficult, tell me the options if there are any.
Sincerely.
Offline
Pages: 1