nanoDLP

macdarren

Member

Registered: 2017-03-20

Posts: 411

minor request for Dashboard add

The new dashboard looks good and I like the 3d preview however I might suggest
changing or adding to it...

Having the angled view is nice to see the model being printed but I think having a side view or two
would be be good...

showing the current layer of color coding the layers as they are printed

maybe even better...

color code layers by time required to print layers for those using dynamic calculations would be nice and then
then showing only those layers so far printed or put an indicator line to show where the current plate is would allow
you to simulate looking into the vat or pausing and raising the platform to see how things are progressing.

I know this is no substitute for real visual inspection for many things could go wrong, but I'd like it if I could see
what the model should look like from the side if I were to pause just to have a visual feel especially If I were
actually comparing the real lifted bed with a nano side view of plate.

Thanks

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: minor request for Dashboard add

It was suppose to be like this, but unfortunately 3D preview is very resource intensive. We cannot run it more than once and I have opt for isometric view of the model.