You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2019-02-06 10:15:08
- VikluhaVaklay
- Member
- Registered: 2019-02-06
- Posts: 17
Only decimals in depth. Build 1932
Hi! After upgrading to 1932 I see only decimals (0.1) in layer height on start page. There were 0.001 before. What is the problem?
Last edited by VikluhaVaklay (2019-02-06 10:21:22)
Offline
#2 2019-02-07 05:40:28
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Only decimals in depth. Build 1932
Slicing strategy has been changed, height still has the same precision
Offline
#3 2019-03-17 11:30:48
- VikluhaVaklay
- Member
- Registered: 2019-02-06
- Posts: 17
Re: Only decimals in depth. Build 1932
Hello, Shahin! After updating to build 2067 I have some bag as on picture below:
Offline
#4 2019-03-17 18:29:21
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Only decimals in depth. Build 1932
Please, share a debug file
Offline
#5 2019-03-25 15:54:07
- VikluhaVaklay
- Member
- Registered: 2019-02-06
- Posts: 17
Re: Only decimals in depth. Build 1932
That's it
nanodlp.debug.-1474346409.zip
Offline
#6 2019-03-25 18:52:24
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Only decimals in depth. Build 1932
Could you share STL/source file? Height detected for the file is wrong.
Offline
#7 2019-03-25 19:11:51
- VikluhaVaklay
- Member
- Registered: 2019-02-06
- Posts: 17
Re: Only decimals in depth. Build 1932
I make SLC in netfabb
There is original STL and my working SLC file
Holder.zip
Netfabb usually produce me SLC with no curing area on the first layer 0.000mm, so I start writing SLC from the second layer.
Offline
#8 2019-03-28 17:00:05
- VikluhaVaklay
- Member
- Registered: 2019-02-06
- Posts: 17
Re: Only decimals in depth. Build 1932
Build 2101 has still the same problem
Offline
#9 2019-03-29 07:51:56
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Only decimals in depth. Build 1932
Fixed on the latest beta. Thank you for the report.
Offline
Pages: 1