You are not logged in.

#1 2019-02-03 06:18:22

Registered: 2018-09-19
Posts: 2

control over projector LED on off via nanodlp win 64 bit version

i have installed a dlp projector in a 3d printer for uv based dlp printing using nanodlp
it is a pc based application with win 64 bit os.
when i start display by clicking the button on nanodlp interface, it displays my desktop wallpaper by default before the first layer display.
so my resin starts curing.
is there any control over hdmi port of pc for starting display exactly at the time of curing the resin during job.


Board footer

Powered by FluxBB