You are not logged in.

#1 2018-11-26 11:29:17

MaxJewels
Member
Registered: 2017-08-10
Posts: 88

Dimensional change X Y

In the past, the XY resolution could be changed in percentage, but now there is written .. X in micron, Y in micron and Z in percent.
res_ov_1.JPG
res_ov_2.JPG
from what I see in the html code, the resolution on X is calculated in resolution, and the Y is calculated as a percentage. Are the old resin profiles no longer compatible with the new version? Or is it a transcription error?
Thanks for the attention

Offline

#2 2018-12-01 20:07:07

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Dimensional change X Y

If you check it more closely you see pairs of similar input which some of them are hidden inputs. So you do not lose previous options but new way of resize is simpler. in a year or two this backward compatibility will get removed

Offline

#3 2018-12-02 08:59:53

MaxJewels
Member
Registered: 2017-08-10
Posts: 88

Re: Dimensional change X Y

So I can currently control the X / Y resolution in micron, if in the machine settings I put only the X resolution and I insert a change in the resin porfile only in X then it will take Y / X as it once was? Or do I have to insert the resolution in X and Y in the machine settings and do the same thing when I change the resin profile?

Offline

#4 2018-12-02 19:59:00

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Dimensional change X Y

Same behavior as before. So X is used as both x/y value in absence of Y

Offline

Board footer

Powered by FluxBB