nanoDLP

grafalex

Member

Registered: 2016-11-19

Posts: 18

'Lift After Print' setting do not work

Hi All,

Can someone describe me difference between using 'Lift After Print' setting, and custom 'Code Before Each Layer' field (where I can also set additional lift movements)?
GCode works fine, but any settings on 'Lift After Print' field are in fact ignored.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: 'Lift After Print' setting do not work

You access Lift After Print value on gcode boxes by using gcode keyword ZLiftDistance

grafalex

Member

Registered: 2016-11-19

Posts: 18

Re: 'Lift After Print' setting do not work

Ah.. thanks.
This was not obvious...