problem with new update 1919 , stop at unspecified layer

mandreas · 2018-11-20 17:40:35

Hi Shahin,

I installed the latest version 1919, in two prints both ended up printing in an unspecified layer, I heard the whistle of end print, possible bug?

Shahin · 2018-11-20 19:25:15

Could you share a debug file? If you have not printed much after.

mandreas · 2018-11-20 20:25:26

here we go.

Shahin · 2018-11-21 04:41:22

Unfortunately not much nanodlp log exists on the debug file, please reproduce the issue and get another debug file.

mandreas · 2018-11-21 08:00:46

Here it is, just done, the problem constantly repeats itself
nanodlp.debug.-784679547.zip

mandreas · 2018-11-22 23:00:33

I understood what produced the problem: I connected the power supply of the LEDs, separate from that of the RPI,

nanoDLP