You are not logged in.

#1 2018-11-09 17:46:31

myk68
Member
Registered: 2017-09-15
Posts: 25

update 1919, cant use the test plate

HI

as it says I now cant use the test plate to check cure times as it puts the print at the 'top' of the screen but that means its to my builds far right that i dont currently print from.

before it used to center it which was fine but \i cant find a way to do this now.

am i missing something??

Mike

Offline

#2 2018-11-09 18:19:27

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: update 1919, cant use the test plate

Calibration plate have not changed for couple of months. What was the last build you have used?

Offline

#3 2018-11-10 16:53:13

myk68
Member
Registered: 2017-09-15
Posts: 25

Re: update 1919, cant use the test plate

it was 18 something but I dont know which.

it still did the block at the top and the separate prints for each size and cure time.

Is there any way to turn the generated test plate by 90 degrees??  I can then use it

Offline

#4 2018-11-26 16:22:30

MaxJewels
Member
Registered: 2017-08-10
Posts: 88

Re: update 1919, cant use the test plate

identical problem
calibr1.JPG
calibr2.JPG

Last edited by MaxJewels (2018-11-26 17:26:33)

Offline

#5 2018-12-02 05:51:09

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: update 1919, cant use the test plate

Max,
Which build you are using? Also share exact values for calibration plate so I could regenerate the issue.

Offline

#6 2018-12-02 08:41:25

MaxJewels
Member
Registered: 2017-08-10
Posts: 88

Re: update 1919, cant use the test plate

Currently using the version 1922, before I was the last stable version, in 18xx but no problem, I think this depends on the fact that the lustration of LCD printers are reversed compared to all other (1440x 2560), the settings are classic however nothing of particular


calib.JPG

Offline

#7 2018-12-30 15:06:24

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: update 1919, cant use the test plate

Increase padding space. I guess it is zero.

Offline

Board footer

Powered by FluxBB