You are not logged in.

#1 2018-11-02 00:29:34

mav1958
Member
Registered: 2018-11-01
Posts: 3

crashing and stop printing wanhao D7 1.5

unstable  wanhao D7 1.5 printers . prints 2-40 layers, then hangs and writes " Waiting for Z-move-comp response from RAMPS". Help please, I'm sick of it. I upload STL file already with supports, then slice to nanodlp. I look at the layers, it's okay. I start on the press and after a while hangs.

Offline

#2 2018-11-02 04:27:32

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,488

Re: crashing and stop printing wanhao D7 1.5

It is probably cable or hardware issue, change cable between ramps and rpi.

Offline

Board footer

Powered by FluxBB