You are not logged in.
I'm setup to use a D7 connected to a Raspberry pi 3B+ but I'm going to do the slicing on windows because the pi locks up on infill calculations.
Hi I'm trying to get the hollowed/infill-hexagonal settings figured out. I'm on Windows x64 build 1886.
As I stated in the subject the 2 settings are not independent. It seems that the Outer Wall setting is ignored and the Wall Size is used for all walls.
I'm not sure if this a known limitation or a bug but it was the same on the previous build I was running as well.
Also there do not seem to be drain holes created at all unless I leave the bottom cap wall set to 0.
I'm new to this software so if I'm missing something let me know.
Thanks
Offline