nanoDLP

JohanStrom

Member

Registered: 2018-08-08

Posts: 5

Extremely slow moves after updating NanoDLP

Hello! I've successfully used NanoDLP for a while now with my Wanhao Duplicator 7, but since upgrading to 1852 (not sure from what, but at least something a month and a half older) my printer still "works" but the lift/layer change cycle is INCREDIBLY slow compared to before. I can't figure out what's changed because all my Gcode and settings are exactly the same as before. Did something change in the software without telling me?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Extremely slow moves after updating NanoDLP

Movement speed being controlled by F parameters on gcode box or on firmware on RAMPS side.

JohanStrom

Member

Registered: 2018-08-08

Posts: 5

Re: Extremely slow moves after updating NanoDLP

I'm not sure, how can I check? It's a NanoDLP install from 3dprinterwiki and the printer is running the repetier firmware modified for D7 recommended on the same site.

I just upped all the speed numbers by an arbitrary amount until it moves as fast as it used to now, but that feels a little unscientific to me .