You are not logged in.

#1 2018-07-03 12:08:50

PMJ
Member
Registered: 2016-05-09
Posts: 9

STL Bigger than Build Area

When importing a STL file which has bigger XY dimensions than the calculated build area Nanodlp is going in an endless loop. The only way to resolve that is to access via putty and manually delete the created folder including all content. Then it's starting up again properly. Would be nice to do a pre check of max dimensions and giving an alert.

Offline

#2 2018-07-05 05:29:05

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: STL Bigger than Build Area

Could you share settings and stl file you are using?
I have not noticed this issue for my own large STL files.

Offline

Board footer

Powered by FluxBB