nanoDLP

SvenBoolie

Member

Registered: 2018-04-29

Posts: 3

Received data from RAMPS: ok

Hey everyone, I finally got my D7 and Raspberry PI up and running. The final portion that seems to be giving me problems is the printing itself   My Wanhao responds to commands such as the Z Axis adjust panel on NanoDLP's dashboard, so I know the printer is set up and working with the software (for the most part).

Whenever I go to start printing my plate, the first task that is presented on the screen comes up as "Received data from RAMPS: ok". This is also the last task that appears, as the progress begins and ends with this message. Has anyone run into problems such as this before?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Received data from RAMPS: ok

Probably you are using incompatible firmware with nanodlp on your printer.

SvenBoolie

Member

Registered: 2018-04-29

Posts: 3

Re: Received data from RAMPS: ok

Well I got it working, there were extra [[Wait for done message]] prompts in the GCode. Now, everything works except for the fact the UV screen doesn't light up to cure the resin, so my resin stays in liquid form and the build plate has no layers adhered to it