You are not logged in.

#1 2018-05-09 18:15:17

Greg209
Member
Registered: 2018-04-25
Posts: 6

Execute code at top after lift (bottom-up printer).

I'd like to take a camera snapshot (via a shell script) at the top of the lift as it's the time where the model will be most exposed to the camera but I can't find an appropriate place to make that call. Is there any place I can add it that I haven't found?

I've seen the likes of syscall after each layer but this happens before the lift, according to this https://www.nanodlp.com/forum/post.php?tid=643&qid=3488

Any help would be appreciated, thanks.

Greg

Offline

#2 2018-05-10 15:39:05

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Execute code at top after lift (bottom-up printer).

Still you can use it as async call to external script which contains wait before taking shot.

Offline

#3 2018-05-10 19:35:32

Greg209
Member
Registered: 2018-04-25
Posts: 6

Re: Execute code at top after lift (bottom-up printer).

That is an option but not ideal, especially if there are different lifts for burn-in layers and normal layer plus slow sections.

It'd would make it difficult to be consistent but I'll try and see how close I can get.

Thanks.

Offline

Board footer

Powered by FluxBB