nanoDLP

SvenBoolie

Member

Registered: 2018-04-29

Posts: 3

Dashboard cannot find my Printer

Hello everyone, I started setting up my D7 1.5 using the YouTube video posted by Model3D called "How To Install NanoDLP On The Wanhao Duplicator 7"

Everything went according to plan, except when I went to the NanoDLP dashboard to connect my printer. In the page, it says that no printers are available on my network, even though I have the Ethernet connection set up to my Router from the Raspberry PI. Am I making a simple error here, or is there a technical issue I should look into? I will try to provide any other relevant information you may need to assist me, sorry for the bare post as I'm new to resin printers as I usually work with Filament printers

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Dashboard cannot find my Printer

If rpi does not have internet access, it is expected. Try use IP assigned on your router to connect to nanodlp.