nanoDLP

The3DPrintist

Member

Registered: 2018-04-28

Posts: 1

No gcode in the terminal during print.

I can control the motor using the Z Axis Control window, but when I print, the motor wont move, and it seems that there is no g code being sent through the terminal window.

It works every other time, during the print I can even type my own g code and get the motor to move, the print just doesn't seem to send any code.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: No gcode in the terminal during print.

You are using incompatible firmware with [[WaitForDoneMessage]] keyword, remove them and use delay keyword or use compatible firmware