nanoDLP

Yianni-VJ

Member

Registered: 2016-05-24

Posts: 95

Restart button does not always restart Rasbian

I have set up my printer to run unattended.

I want to restart the system after slicing to make certain I don't have memory issues during print.
Problem is that restart command works 50%-60% of the time. Is it just me?

Is there a way to make sure the system will restart when I issue the command through nanoDLP?

elshad66

Member

Registered: 2017-03-31

Posts: 118

Re: Restart button does not always restart Rasbian

do not need to restart
if you restart and wait a long time
poor nutrition
put any
https://www.ebay.com/itm/DC-DC-10-12-15 … gjzgH2AcDQ
https://www.ebay.com/itm/5A-Adjustable- … SwUn9aTafX
and install 5.2 volts for power pi

Last edited by elshad66 (2018-04-18 07:22:54)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Restart button does not always restart Rasbian

If you are not using PWM, disabl pigpio binary, it is the causing this issue.

Yianni-VJ

Member

Registered: 2016-05-24

Posts: 95

Re: Restart button does not always restart Rasbian

Hi Shahin,
I googled "disable pi gpio binary" but I can't find instructions on how to do it...
Can you please help?

adam

Member

Registered: 2016-02-18

Posts: 100

Re: Restart button does not always restart Rasbian

There you go:

https://raspberrypi.stackexchange.com/q … stem-start

Yianni-VJ

Member

Registered: 2016-05-24

Posts: 95

Re: Restart button does not always restart Rasbian

Thank you very much Shahin & Adam !
I issued the command:
sudo systemctl disable pigpiod
Restart always responds and memory usage appears to be lower.
Makes me want to try using the camera again, to see if it I can avoid crashes.