You are not logged in.
Pages: 1
Okay, so im getting a wanhao duplicator 7 1.5, i bought a raspberry pi 3 b+ model.
A few questions (i have searched for these)
1: Can i setup NanoDLP without the printer, can i access it online, or does this need a printer connected before i can see the online interface?
2: Do i need to flash firmware on a v1.5 D7 to accept NanoDLP? I had heard that you do not....
3: What is the Easily accessible slicer/support maker for NanoDLP/D7 1.5? (I know it has an inbuilt one, is this fine to use?, can i rotate and scale?, Add Auto Supports?)
Im trying to do my research before diving deep.
Thank you so much for your help guys!
Last edited by Seki (2018-04-16 09:39:45)
Offline
Pages: 1