You are not logged in.

#1 2018-04-14 07:41:01

ikerclon
Member
Registered: 2017-08-22
Posts: 7

Banding when generating plates?

Hi!

I am using build 1778 on a rPi, and when generating plates I noticed there is some sort of horizontal dark lines crossing through what it should be a full white part. I thought it was because I was using a new mask, but it turns out it happens as well with profiles with no mask on them. Here you have a couple of images (sorry for the big size). It is the first time I see this happening.

30705462_210110446248187_1707009261164298240_o.jpg?_nc_cat=0&oh=7da43327ca97e0940f521e4a5328a7c2&oe=5B70063D30709942_210108146248417_4536402976964608000_o.jpg?_nc_cat=0&oh=27f4c04f8992b07f98cbb9ab8aabe00f&oe=5B578D64

Do you have any clue about this?

Thanks!

Offline

#2 2018-04-14 16:39:14

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Banding when generating plates?

You probably have mask on the setup page. And its size is smaller than your actual display so it cause effects like this.

Offline

#3 2018-04-14 20:54:54

ikerclon
Member
Registered: 2017-08-22
Posts: 7

Re: Banding when generating plates?

Thanks for the quick answer! You were right: the mask I was using was tilted 90 degrees. As soon as I changed the orientation, it worked.

Thanks again!

Offline

Board footer

Powered by FluxBB