You are not logged in.

#1 2018-04-11 23:03:43

moudy242
Member
Registered: 2018-04-11
Posts: 4

How to change the center of the screen

I would like the image projected on the screen to be located more towards the edge of the screen not at its center
Can someone help me with specific details. Thank you

Offline

#2 2018-04-12 05:28:14

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,562

Re: How to change the center of the screen

Place pieces wherever you want in 3d editor and do not use center plate when adding plates.

Offline

#3 2018-04-12 05:44:13

moudy242
Member
Registered: 2018-04-11
Posts: 4

Re: How to change the center of the screen

Thanks but this is not what I mean. I need it to be automatic. Where any 3d model loaded to be printed goes automatically to the location even if it is centered in the CAD file.

Offline

#4 2018-04-12 05:54:27

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,562

Re: How to change the center of the screen

Current it does not supported. I am not sure if it 100% achievable with config.txt, but you can try push it to corner using config.txt.

Offline

#5 2018-04-12 06:02:36

moudy242
Member
Registered: 2018-04-11
Posts: 4

Re: How to change the center of the screen

What lines control the position?

Offline

#6 2018-04-13 18:53:54

Doug
Member
Registered: 2017-08-11
Posts: 83

Re: How to change the center of the screen

Overscan, but I can't put it to work

Offline

Board footer

Powered by FluxBB