nanoDLP

tsharris

Member

Registered: 2018-03-10

Posts: 23

I think I found a bug with pixel dimming.

I will have the program hang and disconnect if I do this.

I have an existing plate that I have already printed. If I go into it and edit the resin profile for that plate and change the pixel dimming, then go back to the plate and tell it to recreate, it will hang and disconnect. The only way I will be able to re connect is to SSH in and type this "sudo rm -rf ./printer/public/plates/ "then the plate number". Then shut down the raspberry, restart and go in and delete the plate, I can apply a resin profile with changed pixel dimming if I start a new plate.

I started debug just before initiating the event twice, not sure I did the debug correctly, not sure what to do with them,.... new guy here.

Todd

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: I think I found a bug with pixel dimming.

Could not produce it locally.

Please, go to setup/tools tab/debug and attach the generated file after crash.

tsharris

Member

Registered: 2018-03-10

Posts: 23

Re: I think I found a bug with pixel dimming.

Here it is Shahin

nanodlp.debug.-881353041.zip

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: I think I found a bug with pixel dimming.

Could you crash it again and get another debug file. Unfortunately required details missing on this debug file.