You are not logged in.

#1 2018-02-23 10:35:02

bman
Member
Registered: 2017-09-07
Posts: 11

Soft limits

Is there a way to change the 185mm z height limit?  I wouldn't to set it to 200mm.  Do I have to take the SD card out if my pi and fiddle with the config file to change it?

Thanks

Offline

#2 2018-02-23 10:50:05

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Soft limits

On nanodlp side there is no limit on z height movement except end-switch limit. If you are using RAMPS, try change limits on the firmware side.

Offline

Board footer

Powered by FluxBB