You are not logged in.

#1 2018-02-14 01:37:55

lipreader
Member
Registered: 2018-02-14
Posts: 1

G-code Firmware Calls

Hi, I'm new to NanoDLP and I would like some help on calling our custom firmware commands. I read some topic in G-code but its very hard to understand and grasp the concept when it comes with a combination of firmware calls and NanoDLP G-code. For example, I would like to move the stepper and servo during the printing process, where and how do you code it in G-code. When I type our firmware command in the NanoDLP terminal it works fine, but I tried putting a G-code in Setup->Hardware Setup in NanoDLP, it doesn't move any of our hardware. So I assume that I just put the G-code wrongly. Hope you can point me to some good newbie topics that could help me get started in G-code firmware calls. Thanks in advance.

Offline

Board footer

Powered by FluxBB