You are not logged in.
Hello All,
I bought a 3d printer form china and it come with nanodlp.
All the experience is great and good to know that it's open source.
I was doing some custom work and want to project a single png without move z motor. Any suggestion how can I do that with command line.
I was trying to figure out how to do that and noticed. that all word done by a file called printer, I try to find out it's code to understand how it work, but could not find.
Any suggestion or pointer ?
Thanks & Regards
Piyush Verma
Offline
If you press layers for any plates you can project individual layers as long as you want.
Offline