You are not logged in.
Somebody can help me pls? the piece doesn't get hooked for one side. At the beginning the part is printed on the build plate but after some layers the weight makes unhook of the build plate for one side ( I think). I have attached some pictures so you can see the result of what i say. I have tried different printing parameters. I leave attached the print parameters that I have used for these pieces
Offline
Printer profile Res burn in layers normal layers
ex: mUVe 3D SubSF Red XY75_prova2 75(resolution) 3 (number of layers) 25(Layer thickness) 125(cure time) 52 (Layer thickness) 25(cure time)
mUVe 3D SubSF Red XY75 75 2 100 50 100 9,2
mUVe 3D SubSF Red XY75_prova3 75 3 62,5 87,5 76 17,1
mUVe 3D SubSF Red XY75_prova4 75 3 62,5 87,5 50 10
mUVe 3D SubSF Red XY75_prova5 75 3 62,5 87,5 125 25
mUVe 3D SubSF Red XY75_prova42 75 3 62,5 87,5 50 15
mUVe 3D SubSF Red XY75_prova6 75 20 50 75 75 15
Offline
Picture here!!
Offline
now you can see where the constrution plate is:
https://drive.google.com/open?id=1znZT9 … RJveAZoJvZ
Offline
these three printed in one place or in different?
build plate calibrated horizontally with respect to the screen?
Offline
There were 3 different impressions.
Yes, I did the horizontal calibration. The vat is level correctly
Something strange is happening
help pls
Offline
Check the layers, maybe the model is crooked, on the table
at the beginning prints the left part, and then the right one
Offline