nanoDLP

color

Member

From: Bulgaria

Registered: 2016-03-19

Posts: 84

Temporarily ignore home switch

Hello,
It will be useful if there is a option to enable\disable home switch. I have a mUVe 3D printer and after homing procedure I am lowering the build plate about 0.5mm by turning the leadscrew by hand. My idea is to ignore home switch, go down 0.1 - 0.5mm below home position, set the new position as Z 0 and then enable again the home switch.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Temporarily ignore home switch

The most of endstops used by users are touch, so going below home position is out of question for majority of users.

Please, discuss your idea on muve3d forum, if the responses were positive I will add it.