You are not logged in.

#1 2017-12-07 17:27:11

bridge2nowhere
Member
Registered: 2017-12-07
Posts: 5

Issue talking to arduino

Pi2 -> Arduino running vanilla GRBL -> TB6560 3A Stepper Motor Driver -> Z-Axis Motor

NanoDLP works fine, and I've tried ACM0 and ACA0, but i can't move the Z-Axis using the control buttons, or the terminal.

If i connect the Arduino to GCODE sender on my computer the Z-Axis moves fine, but I can't figure out how to get it to work when connected to my Pi.

Offline

#2 2017-12-07 17:58:01

bridge2nowhere
Member
Registered: 2017-12-07
Posts: 5

Re: Issue talking to arduino

SOLVED, I had a preceding slash in my /dev/ttyACM0 line.

Offline

Board footer

Powered by FluxBB