nanoDLP

georgei

Member

Registered: 2017-09-30

Posts: 21

NanoDlp doesn't accept hole numbers as exposure times when you correct

I have been try to correct my exposure times in a couple of resins.
So I have gone to change the value from 17 second to 15 seconds.

When I have go to save the resin came an error:

"The exposure time must be 14.99999 or 15.0000099"

This was not happening in the previous version.

Is this a bug?

Thank you,

George

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: NanoDlp doesn't accept hole numbers as exposure times when you correct

Could you provide a screenshot?

elshad66

Member

Registered: 2017-03-31

Posts: 118

Re: NanoDlp doesn't accept hole numbers as exposure times when you correct

HI
I had this problem 2-3 times, but with Normal Layers  Layer Thickness   50.000004
I corrected but the program did not accept
"The Layer Thickness must be 49.999999 or  50.000004"
but I did not pay attention,after some time itself corrected

Last edited by elshad66 (2017-12-06 14:59:36)

georgei

Member

Registered: 2017-09-30

Posts: 21

Re: NanoDlp doesn't accept hole numbers as exposure times when you correct

I have attached a screenshot.

George

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: NanoDlp doesn't accept hole numbers as exposure times when you correct

Probably a new bug on a browser. What is it firefox or chrome? and which version?

georgei

Member

Registered: 2017-09-30

Posts: 21

Re: NanoDlp doesn't accept hole numbers as exposure times when you correct

It is Opera 49.0

George