nanoDLP

Belal

Member

Registered: 2017-09-10

Posts: 46

some questions and suggestions about the 3D View

Most of the time all we need is to rotate the part for specific degrees like 90 or 45

I know that there is a freehand way  but it's tricky to adjust the files

Is there any way to do this currently?

and is there is a way to add more than one part together and arrange them so I can print multiple files in one print?

IS nanodlp support auto support generation or it should be done by hand?
and can we expect auto support generation soon?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: some questions and suggestions about the 3D View

Using green button (add with support) on plates you can rotate and add multiple pieces.
Auto support still not ready and I guess it will takes more time to reach to that point.