nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

Printer process has terminated

The printer process has unfortunately terminated at Layer 1285, but Raspberry ran normal.
After the reboot nanodlp stands at Layer 1286.
What I noticed in the logs, apparently exactly on this layer a Logrotate was made from printer.log to printer.log.1.gz

LOG:
nanodlp.debug.-1449308449.zip

I really do not know what happened there . In syslog , the line is
"May  8 00:17:28 raspberrypi systemd[1]: Starting Wait for Plymouth Boot Screen to Quit..."
suggesting that a reboot has been. But this was not the case.

Last edited by Xmike (2016-05-08 11:04:11)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Printer process has terminated

Plymouth could crash the program, is it crashed around 2016/05/08 08:14:50 or May  8 00:17:28?
Checkout crontab -e and /etc/cron.,, folders to see if anything could trigger the problem.

Is it raspian lite or full?

Xmike

Member

Registered: 2016-03-25

Posts: 97

Re: Printer process has terminated

Hi Shahin,

nanodlp runs on raspian lite.
The only thing I additionally installed is webmin.
In "printer.log.1.gz" I can see, that the last Layer was printet at 2016/05/08  00:16:45,
it was also the last entry in this log-file, then a new Log-file "printer.log" was created.

printer.log.1.zip

>crontab -e   -> "no crontab for pi - using an emty one"
>sudo crontab -e   -> "no crontab for root - using an emty one"

Is Plymouth needed, or can I disable it ?

Last edited by Xmike (2016-05-09 10:14:55)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Printer process has terminated

I am not sure why it happened but you can disable it http://askubuntu.com/questions/98566/ho … oot-screen

Check your SD card maybe it is a disk corruption or something else which cause random problems.