You are not logged in.
Offline
Share a debug file. (setup page/tools tab/debug button)
Do you have any idea?
Offline
Unfortunately there are not much in shared debug file. Try to reproduce the issue again just after crash reboot and take another debug file, maybe this time we will be lucky.
Offline
Ok
when I test it I found that if file bigger than print area - system crashed.
why when file loaded I can't control part size?
I'm using another printer for a long time and when I load too small or too big file system notice me about it.
And before slicing I can see how file placed.
In NanoDLP slicing start automaticaly. Why?
Or may be I make something wrong?
Offline