nanoDLP

hoangtruong

Member

Registered: 2021-05-15

Posts: 2

configure lcd to match STL file size

Hi! can anyone tell me this, I use raspberry Pi3 B+ with nanodlp.img file, and 10 inch screen removed from car roof panel, I don't know the resolution of this screen, and the problem mine is when I try to insert the STL cube XYZ file with the size 20x20x20mm, I see on the screen that the first layer is output with a rectangular shape, and the size is much larger than the design of the STL file? so how to edit the actual print size to match the design of the STL file? my LCD monitor is type PFP-SL101127-01A, Thanks All.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: configure lcd to match STL file size

You should change config.txt on Pi, to correct the resolution.