You are not logged in.

#1 2018-12-09 02:07:16

joebywan
Member
Registered: 2017-12-15
Posts: 14

Can't generate calibration plate & how to use windows box as slave

I've set my settings on the calibration plate, hit generate and it isn't generating it.  It's adding the rectangle at the top, but the rest of the objects aren't being added.

ran nanodlp on the same network on my windows box, and it's not showing any output that'd indicate it's being used as a slave for the pi.  Is there something else I have to do?

Offline

#2 2018-12-09 04:59:35

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,567

Re: Can't generate calibration plate & how to use windows box as slave

Make sure you have put proper values on all boxes.

Offline

#3 2018-12-11 01:05:13

joebywan
Member
Registered: 2017-12-15
Posts: 14

Re: Can't generate calibration plate & how to use windows box as slave

Thanks, that helped.  Do you know how to make the windows box help out the raspberry pi slice faster?  Is there a guide somewhere?

Offline

#4 2018-12-12 04:59:59

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,567

Re: Can't generate calibration plate & how to use windows box as slave

Just run nanodlp on windows, raspberry version detect it automatically and handover slicing to windows box

Offline

#5 2018-12-13 02:53:28

joebywan
Member
Registered: 2017-12-15
Posts: 14

Re: Can't generate calibration plate & how to use windows box as slave

Do I have to have the nanodlp on windows running prior to booting the pi? or can I just open it and it'll detect it automatically whenever it tries slicing something?

Offline

#6 2018-12-13 04:42:26

Shahin
Administrator
Registered: 2016-02-17
Posts: 2,567

Re: Can't generate calibration plate & how to use windows box as slave

You can run it before slicing

Offline

Board footer

Powered by FluxBB