you need to correct config.txt file with correct parameters for your mono lcd
I have tried and gotten inside config.txt but it’s empty. I have also looked at some similar samples from others but I don’t exactly know what to put inside config.txt.
Could you help me or point me in the right direction please.
]]>After following the Phrozen Transform group in getting the NanoDLP to setup on my Transform,
I followed all the directions per the instructions on the PDF and everything. I am able to log in thru the Wifi and see the printer and all settings accordingly.
My issue now is my LCD doesn't seem to turn on even when I go into the Display Calibration settings. The UV Light array turns on but not the Mono LCD I have.
Here are the specs for the Mono LCD: 13.3 inch 3840x2160 Mono LCD got it from Alibaba "13.3inch 4k 3840*2160 monochrome LCD screen for 3d sla printer"
I'm assuming I need to have some settings to let the NanoDLP know of my LCD? I have done some test prints and everything runs according to the settings for the printer but no LCD turns on. Any help will be much appreciated. Thank you.
]]>