Use javascript interpreter instead. Sure you can do it depend on height.
]]>[[LayerSkip {([[CurrentPosition]])>0.345)]]
Happy New Year
]]>1. Is this placed in MachineCode page, on start up or in the individual resin profile?
2. Is it binary or can I input a set?
[[LayerSkip 1]]
[[LayerSkip 2]]
[[LayerSkip 3]]...
or
[[LayerSkip (1,2,3,4)]]
3. And do you mean above that all the "Before" and "after" code is skipped?
4. Finally, will this mean it still moves to correct Z height for layer?
Thanks,
E
I would like to:
Skip the first 3 layers, print the 4th
Skip Layers 5,6,7, print 8th.
etc. up to Layer 20 then print remaining layers normally.
Is there a way to use skipped layer or should one use something like Dynamic Cure by using algo cues, if layer number is any to be skipped formula would turn the exposure to 0
However the above I assume would not affect before or after layer subs - so doe these sections need an update as well?
Thanks,
]]>