2020-05-28T17:20:41ZFluxBBhttps://www.nano3dtech.com/forum/viewtopic.php?id=2503I agree, on the 3rd party.
I was thinking that nanosupport is what was required for multi-cure function until I figured it out. Thanks!
]]>https://www.nano3dtech.com/forum/profile.php?id=3552020-05-28T17:20:41Zhttps://www.nano3dtech.com/forum/viewtopic.php?pid=10587#p10587I had a similar issue with some models not having perfectly flat bottoms...not sure how that happened but the feature to offset the bottom allows for the model to be places a tiny amount below the plate so that the first layer will be fully in contact with the plate. Agree a lay flat would also be useful at times but most third party support generators do the lay flat process and the exports then sit flat in nano too.]]>https://www.nano3dtech.com/forum/profile.php?id=6552020-05-19T04:44:50Zhttps://www.nano3dtech.com/forum/viewtopic.php?pid=10539#p10539Elliot,
Could you share a sample file?
]]>https://www.nano3dtech.com/forum/profile.php?id=22020-05-19T04:10:50Zhttps://www.nano3dtech.com/forum/viewtopic.php?pid=10533#p10533Still having import issues with some STLS. It would be great to have a lay flat command. Sometimes the tilt is so slight that even 0.1 degree does not work.]]>https://www.nano3dtech.com/forum/profile.php?id=3552020-05-18T18:02:27Zhttps://www.nano3dtech.com/forum/viewtopic.php?pid=10530#p10530