Speed settings only being used on direct control mode but for RAMPS and shield users, it is also accessible on gcode boxes.

Type of Speeds

Min Speed - On Setup
Being used when prints dip into resin.
Startup Speed - On Setup
Being used for acceleration. It should not be to high, as it possible to lose steps.
Max Speed - On Setup
Being used as the top speed when printer is not printing.
Slow Section Speed - On Profile
Speed which being used when distance of platform to tank floor is less than this value.
Max Speed - On Profile
Max speed during printing
Dynamic Speed - On Profile
Override every speed exluding startup speed during printing.