nanoDLP

terraformer

Member

Registered: 2019-07-01

Posts: 2

Unable to start printing

I`m trying to use nanoDLP with a Wanhao D7 and here is another problem: When I upload and slice stl file, the warning "The plate is not sliced yet." does not disappear and if I try to print such plate, the printer just goes idle. Regenerating a plate does not help. This is how it looks like:

And here is the plates section while it is "printing":

Some time before my friend figured out how to get this system to work somehow. But now I (a complete total noob) have to reinstall the nanoDLP. At this moment Z axis and LCD work fine but I can`t start any print. Do you know any possible reason why it behaves like this?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Unable to start printing

Looks like two different issues. One is not sliced message which I am not sure why happens. Share a debug file.
The second issue is probably wrong gcodes. even-though you are using correct firmware based on the shared screenshots. You have extra [[WaitForDoneMessage]] in your gcode box. Usually after G1 you should put such commands.

terraformer

Member

Registered: 2019-07-01

Posts: 2

Re: Unable to start printing

That`s what I came out with yesterday. I removed all [[WaitForDoneMessage]] after all instructions not for movement. about those messages - I just rolled back to a previous version and now it`s gone. I`ll try to investigate this problem later when i`ll have time for it