nanoDLP

F.m

Member

Registered: 2017-12-22

Posts: 147

sicube SM7 help

hi Shahin,
recently i bought a si-cube SM-7, i could turn it on and off in setup/display settings by binary codes, but i can't turn on/off the LED it self before/after each layer by code (it is on steadily). i couldn't find anywhere to put the led binary on/off command to execute before and after each layer. i tested gcode boxes before and after layer in resin profile but it didn't work.

Last edited by F.m (2019-05-19 12:34:41)

F.m

Member

Registered: 2017-12-22

Posts: 147

Re: sicube SM7 help

in fact, i need to know where to put binary codes to communicate with projector serial port before and after each layer

F.m

Member

Registered: 2017-12-22

Posts: 147

Re: sicube SM7 help

i successfully made it work